Go Back   Alberta Outdoors Forum > Main Category > General Discussion

Reply
 
Thread Tools Display Modes
  #1  
Old 11-14-2022, 10:05 PM
slopeshunter's Avatar
slopeshunter slopeshunter is offline
 
Join Date: May 2007
Posts: 2,224
Default Electrical Question

Hi All,

I’ve got this outlet on the outside of the house. Used to work fine, now for some reason it doesn’t work at all. There’s no breakers flipped on the panel.
What could the problem be and what might the solution be.

Thanks
Reply With Quote
  #2  
Old 11-14-2022, 10:11 PM
Twisted Canuck's Avatar
Twisted Canuck Twisted Canuck is offline
 
Join Date: Jul 2009
Location: GP AB
Posts: 16,753
Default

It is a GFI, or protected by another GFI plug? Maybe that is tripped?
__________________
'Once the monkeys learn they can vote themselves a banana, they'll never climb another tree.'. Robert Heinlein

'You can accomplish a lot more with a kind word and a gun, than with a kind word alone.' Al Capone
Reply With Quote
  #3  
Old 11-14-2022, 10:14 PM
slopeshunter's Avatar
slopeshunter slopeshunter is offline
 
Join Date: May 2007
Posts: 2,224
Default

Thanks TC. That makes sense, it could be connected to a GFI. I’ll check, thanks.
Reply With Quote
  #4  
Old 11-14-2022, 10:16 PM
FortMac FortMac is offline
Banned
 
Join Date: May 2021
Posts: 358
Default

Is there power on the CCT? Have you tried replacing the receptacle?
Reply With Quote
  #5  
Old 11-14-2022, 10:30 PM
slopeshunter's Avatar
slopeshunter slopeshunter is offline
 
Join Date: May 2007
Posts: 2,224
Default

Quote:
Originally Posted by FortMac View Post
Is there power on the CCT? Have you tried replacing the receptacle?
No, I haven’t tried replacing the receptacle yet. Not sure what the CCT is
Reply With Quote
  #6  
Old 11-14-2022, 10:32 PM
dr.crentist dr.crentist is offline
Banned
 
Join Date: Feb 2020
Posts: 196
Default

9 times out of 10 it’s a tripped GFCI, reset it and all good. The exterior receptacles should all be in the same circuit and downstream of the main GFCI, given the house is newer and wired to code. Find the first receptacle in the circuit, usually closest to the main panel, and see what the status is. If one doesn’t work and others do, it could be a different story
Reply With Quote
  #7  
Old 11-14-2022, 10:33 PM
FortMac FortMac is offline
Banned
 
Join Date: May 2021
Posts: 358
Default

Quote:
Originally Posted by slopeshunter View Post
No, I haven’t tried replacing the receptacle yet. Not sure what the CCT is
Is there power on the Circuit.
Reply With Quote
  #8  
Old 11-14-2022, 10:42 PM
slopeshunter's Avatar
slopeshunter slopeshunter is offline
 
Join Date: May 2007
Posts: 2,224
Default

^^^ gotcha. Thanks guys, got some stuff to check out in the daylight.
Reply With Quote
  #9  
Old 11-15-2022, 01:42 PM
ATF ATF is offline
 
Join Date: Jun 2007
Posts: 687
Default

Son bought a new house and the home inspection said the outside outlet was dead. Son later realized there was a switch installed for the Christmas lights in the closet and it was off. Possibility?
Reply With Quote
  #10  
Old 11-15-2022, 01:47 PM
slopeshunter's Avatar
slopeshunter slopeshunter is offline
 
Join Date: May 2007
Posts: 2,224
Default

Quote:
Originally Posted by ATF View Post
Son bought a new house and the home inspection said the outside outlet was dead. Son later realized there was a switch installed for the Christmas lights in the closet and it was off. Possibility?
We do have a switch for lights. I’m going to check!

That was a great suggestion unfortunately not the case with my house. More digging after the work days done. Thanks though. I was real excited that would be it lol
Reply With Quote
  #11  
Old 11-16-2022, 10:41 AM
zabbo's Avatar
zabbo zabbo is offline
 
Join Date: Apr 2009
Location: calgary
Posts: 1,566
Default

Quote:
Originally Posted by slopeshunter View Post
We do have a switch for lights. I’m going to check!

That was a great suggestion unfortunately not the case with my house. More digging after the work days done. Thanks though. I was real excited that would be it lol
Switch in closet will be for the soffit plug along the eaves somewhere. Yes, for xmas lights. Not sure if it has been mentioned, sometimes when a breaker trips people will just go to the panel, and turn it back on. They think it is reset, but not so. You have to turn the breaker off and then reset it. Been a few places where that was the case. Best bet is a tripped GFI.
Reply With Quote
  #12  
Old 11-16-2022, 11:14 AM
urban rednek's Avatar
urban rednek urban rednek is offline
 
Join Date: Jul 2016
Posts: 3,718
Default

A couple more ideas to check:
1. Convenience receptacle near the electrical panel. If it is a GFCI, it could be protecting the outside plugs.
2. GFCI in main floor 1/2 bath could be protecting the outside plugs.

I've seen both situations cause a lot of frustration. It's only funny after you get it figured out.
__________________
“One of the sad signs of our times is that we have demonized those who produce, subsidized those who refuse to produce, and canonized those who complain.” - Thomas Sowell

“We seem to be getting closer and closer to a situation where nobody is responsible for what they did but we are all responsible for what somebody else did.”- Thomas Sowell
Reply With Quote
  #13  
Old 11-16-2022, 12:11 PM
Rig-Rat's Avatar
Rig-Rat Rig-Rat is offline
 
Join Date: Jun 2014
Posts: 2,315
Default

Is there a dead front GFCI next to the electrical panel?? Looks like a plug with no holes... Hit the trip then reset.
Reply With Quote
  #14  
Old 11-16-2022, 01:05 PM
Landshark Landshark is offline
 
Join Date: Jul 2022
Location: Spruce Grove, AB
Posts: 231
Default

First things first. Check the GFI's in the house as mentioned above. If that's not it, plug something in that is known to work to see if you have power or not. Also check other plugs on the circuit to see if they have power. If not, turn the breaker off then remove the plug (not the wires) as in pull it out so you expose the wires attached to the plug. Now turn the breaker back on. Using a multi meter, check to see if you have power at the wires. If yes, replace said plug. If not, maybe the breaker is faulty. If you electrocute yourself, you never read any of this advice. It's just for entertainment value.
Reply With Quote
  #15  
Old 11-16-2022, 06:55 PM
deerhunter deerhunter is offline
 
Join Date: Apr 2008
Location: Just North of the North Sask. River
Posts: 1,210
Default

Had a house that had aluminum wiring
Same thing no power to outside receptacle
The aluminum wire was burnt off the screw terminal
Reply With Quote
  #16  
Old 01-17-2023, 04:57 PM
slopeshunter's Avatar
slopeshunter slopeshunter is offline
 
Join Date: May 2007
Posts: 2,224
Default

Quote:
Originally Posted by urban rednek View Post
A couple more ideas to check:
2. GFCI in main floor 1/2 bath could be protecting the outside plugs.

I've seen both situations cause a lot of frustration. It's only funny after you get it figured out.
Well, I thought I come back and close this one off. It was the GFCI in the main floor bath. But it never entered my mind because that outside plug has to be the furthest thing away from that plug in the bathroom lol. Just as urban rednek said, frustrating and then funny.

Thanks for all the input I do appreciate it.
Reply With Quote
  #17  
Old 01-18-2023, 10:55 AM
Big Grey Wolf Big Grey Wolf is offline
 
Join Date: Sep 2012
Posts: 6,439
Default

Found many cheaply manufactured receptacles from our favorite country in the East do not stand up to weather and need to be replaced with quality ones.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 07:59 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.